微波EDA (m.ostronger.com) 網友回復：

• 網友回復

  重貼一下報錯內容：
  Simulation / Synthesis Messages
  
  Warning detected by hpeesofsim in topology check during circuit set up.
      Number of nodes with only one device attached (topology corrected): 5
      Number of nodes with no DC path to ground (topology corrected): 19
  Error detected by hpeesofsim during TRAN analysis 'SP1'.
      `test_1': S-parameters are not available at 0 Hz.
  Error detected by hpeesofsim during TRAN analysis 'SP1'.
      Fatal error occurred while evaluating model `MomCmpt', instance `test_1'.
  
  Status / Summary
  
  
  hpeesofsim (*) 331.200 May  6 2008 (built: 05/06/08 00:26:15)
  Copyright Agilent Technologies, 1989-2008.
  
  ******************************************
  ***** Abnormal Simulator Termination *****
  ******************************************
  The simulator has unexpectedly terminated.

• 網友回復

  可能是你在layout下的頻率設置和schematic下的不同。

• 網友回復

  頻率設成一直也不管用啊，那位高手幫忙解答胰一下怎么化解�。�
  Simulation / Synthesis Messages
  Warning detected by hpeesofsim in topology check during circuit set up.
      Number of nodes with only one device attached (topology corrected): 10
  Error detected by hpeesofsim during SP analysis 'SP1'.
      `X090224_output_1': Syntax error in the Layout Component ModelDatabase citi-file.
  Error detected by hpeesofsim during SP analysis 'SP1'.
      Fatal error occurred while evaluating model `MomCmpt', instance `X090224_output_1'.
  Status / Summary

申明：網友回復良莠不齊，僅供參考。如需專業解答，推薦學習李明洋老師的ADS培訓視頻，或咨詢本站專家。